|
Big Block Talk! Everything about swapping a big block engine into your cart! |
|
Thread Tools | Display Modes |
05-21-2012, 12:07 PM | #1 |
Not Yet Wild
Join Date: Feb 2010
Location: North Carolina
Posts: 49
|
Belt Size Help !!
I have installed a 16 hp vanny in my 93 CC, I’m using the stock clutches with the adapter from Tom. I measured around the inside of the drive and the outside of the driven and it is 42" add 2" according the posts I have seen on here, so I need a 44" belt. I figured that if I am using the stock clutches then the belt should be stock 1" wide, so if I did all this right I need a 1" x 44" belt. Now with all this said I have found a belt at NAPA, part # 19T4440, 1 3/16" x 44 3/8", these is as close to 1" x 44" I can find without surfing the web for hours. I feel like I can adjust the 3/8" out by moving the motor up, but will the 3/16" be a problem on the width?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
belt size for an 86 DS with a 96 clutch. | Gas Club Car | |||
Belt size | Gas EZGO | |||
Belt size | Gas Yamaha | |||
Different Belt Size? | Gas EZGO | |||
proper belt size | Gas EZGO |