Correct orientation for Nissan Leaf Modules and plates?

[somfas]

Before I get these all strung up, can you guys please confirm if this is the correct use of these plates? I’m talking about the original braces / end plates and spacers. I have four endplates. Two with this seemingly useless tab sticking out (near the terminals with a hole for some random bolt that would not ha e an application in my cart) and two without. The spacers I assume must go like I ha e them, but it seems sloppy. Thanks

[somfas]

I can’t find a way to upload rom my phone. Sorry. Is there any links to proper assembly? I searched and couldn’t find anything. Thx

[somfas]

I can't find a way to delete this thread unfortunately. However, for anyone looking at this for reference, I have found comments in threads here that the factory spacers are not that important. In these Gen 1 modules, you can use regular washers if you don't have the spacers. With that in mind, I would assume the correct orientation of these factory spacers is irrelevant. I still am not sure of the correct installment of the end plates, however there are many people using aluminum and plywood end plates, so I assume that doesn't matter either; as long as they are squeezed together. I remember seeing a thread awhile back that gave the measurements of the modules before and after the endplates applied the proper "squeeze". There is also this thread about boxes. http://www.buggiesgonewild.com/all-t...m-boxes-2.html