Can't get new Alltrax DCX500 and motor working....HELP!!!!
I have a 2001 EzGo PDS and the contoller / motor went out not long ago. I ordered a new EY7-4001 motor, DCX500, 3amp diode, resister, fuse, 2awg cables, 400 amp Solenoid w/ bracket.
I installed all of the above according to the wiring diagram and get nothing out of the DCX. No green LED or nothing. I went over and over the diagram, checked my diode to make sure the white stripe was facing the postive connector that connects to battery. I connected the small red wire to the positive connection on the Solenoid that runs to the battery. The yellow wire is connected to the #1 position on the solenoid, and blue is connected to #2 position. I am not sure where all to check for voltage. I have 38-40vdc passing thru the solenoid.
I am wondering if my wiring harness got damaged when the controller melted? Also my volt meter does not come on either. I can get some pics if needed. I am also planning on calling EV Drives since I ordered them from there and see if they can help. After that I will call Alltrax. Just wondered if anyone knew where to test first.
Thanks Brian
|