|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
|
01-31-2019, 05:18 AM | #1 |
Not Yet Wild
Join Date: Jun 2016
Posts: 4
|
2014 precedent will not move after intense pressure wash
This cart was rigorously cleaned everywhere and looks great but.....
Batteries fully charged and good (tested with a battery load tester) Battery meter showing full Tow/Run switch - Run Keyswitch - on Forward - buzzer sounds - no movement Neutral - no buzzer Reverse - buzzer sounds - no movement Please guide me where to start |
01-31-2019, 08:42 AM | #2 |
revolutiongolfcars.com
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 10,224
|
Re: 2014 precedent will not move after intense pressure wash
Water in the F&R switch. Pop the switch out of the housing with a screwdriver and remove it. Pay close attention to how it's wired before you disconnect the wires. There are two release tabs at the base of the switch that allow you to take it apart. Take it apart and dry it out and re-assemble it. It'll work. Very common problem.
|
01-31-2019, 11:10 AM | #3 |
MOD of all BS!
Join Date: Sep 2011
Location: Florida
Posts: 17,477
|
Re: 2014 precedent will not move after intense pressure wash
If you seal the connections while it is apart, that will usually help prevent it again....
|
03-02-2019, 06:05 AM | #4 |
Not Yet Wild
Join Date: Jun 2016
Posts: 4
|
Re: 2014 precedent will not move after intense pressure wash
Thanks guys! Perfect!
|
|
|
Similar Threads | ||||
Thread | Forum | |||
2014 Yamaha 48v won't move | Electric Yamaha | |||
2014 ezgo will not move | Electric EZGO | |||
2014 EZGO RXV will not move | Electric EZGO | |||
Ezgo wont move after wash | Electric EZGO | |||
Pressure Wash Engine? | Gas Yamaha |