|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
07-26-2011, 05:55 PM | #1 |
Not Yet Wild
Join Date: Jun 2011
Location: montgomery al
Posts: 16
|
2007 txt 36 volt
Remove batteries about 3 weeks ago. Cleaned battery post and cleaned and repainted battery carrieage area. Have been preparing cart for paint job. Got cart ready to paint. Replaced batteries (have 38volts). Cart will not go. controller will click but not response. HELP!!!
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-30-2011, 03:14 PM | #2 |
Not Yet Wild
Join Date: Jun 2011
Location: montgomery al
Posts: 16
|
Re: 2007 txt 36 volt
I still need help. If anyboby has any ideas they would be appreciated.
Thanks Hollis |
07-30-2011, 03:28 PM | #3 |
......................
Join Date: Apr 2009
Location: FT Lauderdale FL.
Posts: 16,416
|
Re: 2007 txt 36 volt
where is your F/R switch, on the dash or by your knee
|
07-30-2011, 03:47 PM | #4 |
Not Yet Wild
Join Date: Jun 2011
Location: montgomery al
Posts: 16
|
Re: 2007 txt 36 volt
Knee. It is a series cart.
|
07-30-2011, 03:57 PM | #5 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,358
|
Re: 2007 txt 36 volt
TXT Series solenoid activation circuit
Power starts on the White wire on the 36+ of the battery pack. Power travels to the charger receptacle, goes through a reed switch inside the receptacle and comes out on the red 12 gauge red wire. ( check for power here, 1st!) The red wire travels back through the loom to the Forward and reverse switch where it attaches to a micro. The other side of that micro has a blue wire attached that runs under the cart to the front and arrives at the keyswitch. The keyswitch then transfers power to a green wire which returns to the area of the Forward and Reverse switch. the power then goes through a 4 pin Molex connector and travels to the "pedal Box" (located under the floorboard of the car) where it goes through a micro and comes out on another red wire. That red wire comes back up to the Controller/F&R area where it once again goes through the 4 pin molex connector and continues on to the small post of the solenoid. |
08-03-2011, 02:47 PM | #6 |
Not Yet Wild
Join Date: Jun 2011
Location: montgomery al
Posts: 16
|
Re: 2007 txt 36 volt
Problem solved. Cleaned cable ends, cleaned and realign contacts on F&R switch. Seems to running good for now.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
2007 Ez Go 48 volt PDS II Parts | Golf Carts and Parts | |||
2007 36 volt ez go | Golf Carts and Parts | |||
Light kit for 2007 txt 36 volt series | Electric EZGO | |||
2007 48 volt club car not working | Electric Club Car | |||
48 Volt Conversion for 2007 Freedom SE | Electric EZGO |