|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
04-12-2021, 09:02 AM | #1 |
Gone Wild
Join Date: Mar 2013
Posts: 307
|
2016 EZ GO Txt only goes 8mph
I have a 2016 ez go Txt that I have programmed to 14 mph with my handheld. I tried to program it to coastal and hills, but still goes 8mph. There was a speed sensor fail and I have since replaced it, but still goes 8 mph. The battery pack was reading 50v even know the Trojan batteries are 5 years old.
I am not getting any codes any longer since replacing the speed sensor. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-12-2021, 09:04 AM | #2 |
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,005
|
Re: 2016 EZ GO Txt only goes 8mph
Need to check what mode it is in.. Sounds like Airport
|
04-12-2021, 09:34 AM | #3 |
Gone Wild
Join Date: Mar 2013
Posts: 307
|
Re: 2016 EZ GO Txt only goes 8mph
I have it in Coastal and speed is at 14.8.
|
04-12-2021, 09:59 AM | #4 |
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,005
|
Re: 2016 EZ GO Txt only goes 8mph
Should be able to monitor it while driving and make sure that your throttle is getting to 100%. Also for grins change it to another mode and see if anything changes
|
04-12-2021, 10:02 AM | #5 |
Gone Wild
Join Date: Mar 2013
Posts: 307
|
Re: 2016 EZ GO Txt only goes 8mph
Ok, will try that tonight. Thank you!
|
04-16-2021, 10:51 AM | #6 |
Gone Wild
Join Date: Mar 2013
Posts: 307
|
Re: 2016 EZ GO Txt only goes 8mph
So I checked all codes and no matter what I set it for, it still goes 8mph. Also after two different speed sensors I still get a speed sensor error. In monitoring the handheld, the speed stays at 0 when driving it.
I tried the reader on another cart and was able to see the speed when accelerating. Would a controller issue give me a speed sensor error? I am going to run an OHM test on the speed sensor wires this weekend. |
04-16-2021, 02:29 PM | #7 |
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,005
|
Re: 2016 EZ GO Txt only goes 8mph
If it is not seeing the sensor it will do this. Check the magnet and make sure it is okay as well as checking the wires from the sensor to the controller.. May have bent a pin in the connector.
|
05-04-2021, 06:35 PM | #8 |
Gone Wild
Join Date: Mar 2013
Posts: 307
|
Re: 2016 EZ GO Txt only goes 8mph
Ok so I put a new speed sensory on it and magnet but still get the speed sensor error. I did an ohm test to the controller and the wires are fine.
Controller bad? |
05-04-2021, 11:08 PM | #9 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: 2016 EZ GO Txt only goes 8mph
Push the cart around, does it resist pushing? I think I it should. I say "I think" because we sell very few 48v txt's, so I dont exactly "know them like the back of my hand". Does it still show '0" for motor speed while driving?
|
05-10-2021, 09:28 AM | #10 |
Gone Wild
Join Date: Mar 2013
Posts: 307
|
Re: 2016 EZ GO Txt only goes 8mph
Thank you for the information. It was the controller. It is working as it should after replacing the controller.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
2014 Club Car Precedent will only go 8mph | Electric Club Car | |||
2015 ezgo txt only 8mph? | Electric EZGO | |||
Top speed of 8mph After battery install | Electric Club Car | |||
Please help 2008 club car precedent only goes 8mph | Electric Club Car | |||
G21a Yamahauler top speed of 8mph!!! | Gas Yamaha |