Stealth Patriot Electrical help

[hobbicam]

Hello All,

I have a 09 Stealth Patriot. It seems that early yesterday, I went to the garage and unplugged to ready to move the Patriot, but it just made a click at that "GO" pedal, as if it normally does but this time it did not move.

I back the patriot into the garage and all seem to be fine when I backed it in. then a few days later, this happened?

Where can I start? Here is what I have tried but had little time this morning before work.

1. rubber malet bumping the relays.
2. tested batteries shows 74V
3. switch on 4x4 and tried, then back to 4x4.

is there a reset, maybe I need to disconnect the batteries, which I did not.

Does anyone have that box that is under the floor board where Go pedal is connected to? I hear the click there and wondering if power is not getting to any of the motors.

Arrgg.. thank you for all your help.

Hobbicam.

[sunoco]

That "box" is the MCOR. It sounds like the 48v Albright activation solenoid isn't activating. I would start there. You can try jumping the 2 larges posts on the square single solenoid. Do this with unit on jack stands.