|
Gas Club Car Gas DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
07-11-2019, 05:38 PM | #1 |
Not Yet Wild
Join Date: Aug 2018
Posts: 5
|
rebuilt starter now running backwards
I put new brushes and sanded the armature. Everything look very good but I did not mark the wires where they came from. I found some info on line that put the jumper wire F1 to A2. A1 neg and F2 pos. This spins the motor ccw on the pulley end of the starter. The gas engine has an arrow on it that shows it needs to spin cw. I get a lot of load barking out the intake so bad I can not hold my hand over it. I opened the valve cover and it look like the valve were working normally and not being held open as I first thought.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
rebuilt starter now running backwards | Gas EZGO | |||
I just rebuilt 84 2pg and not running HELP! | Gas EZGO | |||
Engine running backwards | Gas Club Car | |||
Carryall running backwards when stopping | Gas Club Car | |||
87 Club Car Gas f82-Is it Running Backwards? | Gas Club Car |