NEOS 48M350B programming cable problem

[vk4444]

Is anyone able to send me the progam to the NEO's?

[raed]

Originally Posted by BobInDaytona

In the FTDI Program, mine shows up, starting with Chip Type, and ending at EEPROM Type:

FT245R
0x0403
0x6001
CANUSB
LW0GQxxx
LAWICEL
0x131
Internal EEPROM

Not sure what the software is actually looking for. I think you can edit
one or more of these...

Thanks a lot my friend for your effort with me!
I try all my best but the adapter I have not work at all with the Tune program, so I ordered The USBCAN adapter from LAWICEL(cost me around 250$ with shipping and customs) then download the driver and wire it to the controller and works fine.
So thanks a lot for your time.

But as an Embedded System developer, I will listen to CAN bus and see why other adapter does not work with this program.

[raed]

Originally Posted by vk4444

Is anyone able to send me the progam to the NEO's?

Done, see your DM

[Remon]

hi
did any one send you Neos software .. can you please forward a link

[ATrain]

Originally Posted by raed

Any help will be appreciated
I have also mcp2515 which I can connect with Arduino to be seen as a COM port. But I think the adapter I have must work with the correct configuration, or do I need to buy CANUSB from LAWICEL?
https://www.canusb.com/sales/

Thanks in advance!

I've said it a bunch elsewhere, but YES you need to buy that specific CANUSB from LAWICEL.

It sucks, but that CANUSB comes with DLL's that make things easier for ICON to develop. The only way around that device is decompiling and rewriting the ICON Tune software to communicate over a different CANBUS.

Just think of it like the standard CANUSB protocol is like binary 01010101 and ICON chose to use a specific CANUSB device that comes with helpers so they don't need to program directly in binary but instead can program at a higher abstraction layer and say "writeToDevice("MAX RPM", 7000);".

It makes it easier for ICON but locks the software to that device.

[Wtg200]

Could someone please send me and updated version of the NEOS controller software download link? Thank you in advance!

[Wtg200]

Could you also send me an updated neos software link as well? I would greatly appreciate it!