Big mistake with wiring light package? Please help!

[n0stawttam]

So as I was trying to install the switch for the lights from the club car precedent Madjax lift kit light setup, I was taking the plugs out of the back of the switch to get it to go through the dash, and 1 of the plugs did not pull out correctly, pulling just the wire and not the connection itself.

Based on their videos online, which are outdated, the switch is totally different than the video. I'm hoping the yellow wire I pulled out of this switch is the 1 I will not re-use when I re-wire it with the ultimate light package for the turn signal. The brown cord (see picture) states it is the light power, but have not used a voltage meter to confirm. If the brown is indeed the power switch, then I'd only be using that one and the 2 wires off the ultimate light kit, correct? I will be switching to a push pull light knob instead of the rocker switch anyways as this 1 was broken out of the package as well. (did not move side to side when pressed)

PLEASE HELP!