|
Big Block Talk! Everything about swapping a big block engine into your cart! |
|
Thread Tools | Display Modes |
08-09-2016, 05:16 PM | #1 |
Not Yet Wild
Join Date: Apr 2014
Posts: 20
|
B&S 16 hp V-Twin
i just acquired a 16 HP V-Twin that was on a generator fresh build,has tapered shaft where can i get a clutch that will fit??
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-09-2016, 05:27 PM | #2 |
Not Yet Wild
Join Date: Jul 2016
Location: Huntsville, Alabama
Posts: 23
|
Re: B&S 16 hp V-Twin
Is the problem that you need a straight shaft? If so it may be easier to replace the shaft. Those are usually just bolted to the engine with 3 or 4 bolts.
|
08-09-2016, 05:28 PM | #3 |
Gone Wild
Join Date: May 2012
Location: Rio Verde, Az
Posts: 7,125
|
Re: B&S 16 hp V-Twin
You should move this to the Big Block forum. This is the Electric forum.
|
08-10-2016, 11:19 AM | #4 |
Gone Wild
Join Date: Jan 2014
Location: Medina ohio
Posts: 914
|
Re: B&S 16 hp V-Twin
Check out this thread it will help u out and give u a couple options http://www.buggiesgonewild.com/big-b...or-engine.html
|
08-12-2016, 09:38 AM | #5 |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,433
|
Re: B&S 16 hp V-Twin
Most generators have a long taper that is different than the cart and snowmobile taper. The 30mm taper commonly used on carts is about 1" long roughly and the small part is over 1" diameter. There are a few ways to make the gen taper work, listed in other threads. You can machine it, swap the crank out, etc.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
48 volt twin motor twin 500 amp controllers on lithium power | Electric EZGO | |||
hf v twin | Clone Engine Swaps | |||
FYI HF twin for $525 | Clone Engine Swaps | |||
Briggs V-Twin - Twin Carburettor Question | Big Block Talk! | |||
v twin | Golf Carts and Parts |