|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
01-31-2014, 12:25 PM | #1 |
WILD
Join Date: May 2007
Location: lebanon county,pa
Posts: 1,266
|
600 amp alltrax error codes
I have a 600 amp alltrax controller that was working fine a month ago but I went to use it today and I've got 4 flashing red light code controller over 95c now it was 0 degrees out for a while but I don't know what could be wrong. Also the solinoid isn't clicking. Any ideas?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-31-2014, 01:10 PM | #2 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 600 amp alltrax error codes
Alltrax makes several types of 600A controllers. Are you speaking about the one identified in your signature block?
If so, and you have it wired according the the Alltrax AXE in a EZGO series cart, the solenoid should have voltage applied to one of the small terminal when the controller is powered up. (Wire from pedal switch feeds both Pin-1 on controller and one side of solenoid coil) Solenoid not clicking could be a bad connection on that wire (there is a splice in the wiring harness that fails) Could be a bad connection between the B- terminal on controoler to the other side of solenoid coil. Could be a bad solenoid. ---------- Error code might be due to low pack voltage, or a bad controller. Maybe it just does like being cold. Alltrax says the error codes might mean....., so you've got an error that might mean...etc. etc, etc. Charge the batteries and use a hair dryer to warm the controller up a bite and see what happens. |
01-31-2014, 01:50 PM | #3 |
Gone Wild
Join Date: Jul 2013
Location: Mid Michigan
Posts: 207
|
Re: 600 amp alltrax error codes
JohnnieB - could it be a fail on the temp sensor? - reporting over 95C when it is 0?
Could be an open or short on the sensor or its wiring. |
01-31-2014, 03:06 PM | #4 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 600 amp alltrax error codes
Quote:
Or the error code could be a false error that is being caused by something other than a temperature over 95°C. ---------- There are two problems. 1. Solenoid not clicking 2. Error code # 4 The solenoid not clicking is external to the controller. In a series cart, it should click whether the controller is good or bad. The Controller has to power up to give an error code and the final step is to close the Pedal switch, which also sends pack voltage to the solenoid, so we know that voltage is through the pedal microswitch. |
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
New to me 96 DCS with Alltrax DCX 300 open field error | Electric EZGO | |||
Open field error with alltrax dcx300 on a 1996 or 1997 dcs | Electric EZGO | |||
Alltrax SPM no error codes but not working | Extreme DC! | |||
Alltrax SPM "low throttle" error code | Electric EZGO | |||
OBC Error codes | Electric Club Car |