|
|
|||||||
| Big Block Talk! Everything about swapping a big block engine into your cart! |
  |
|
|
Thread Tools | Display Modes |
04-15-2025, 06:31 AM
|
#21 |
|
Not Yet Wild
Join Date: Dec 2023
Location: NC
Posts: 4
|
Re: Common 670 Solutions
I ordered the Vegas Carts tach, wired and calibrated as per their instructions. I soldered the signal wire to the kill wire spade terminal at the coil and also changed the coils to the 30500-ZJ1-013 coils from Amazon. These engines have a diode box inline for the kill wire with one wire going into the box then 2 wires coming out going to each coil. Can this diode box be removed and so called straight wired to the kill wire?
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Cart Storage solutions? | Garage and Workshop | |||
| G29 camber solutions | Gas Yamaha | |||
| Low(er) Cost Wheel Solutions | Design Center | |||
| Throttle cable solutions | Design Center | |||
| Battery maintenance- Solutions | Electric EZGO | |||
Linear Mode
