07-01-2021, 05:23 AM | #1 |
Not Yet Wild
Join Date: Aug 2017
Posts: 28
|
BMS and Alltrax settings for leafs?
So my 14 modual leaf pack is finally in my Precedent and everything is wired and seems too be working as it should.
I know I've seen a post here about the settings for a Chinese BMS. Maybe it was a screenshot? I've searched and searched but I guess I'm using the wrong words. Would someone care to share that with me? Also should I just contact Alltrax for optimal settings for my 300? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-01-2021, 06:24 AM | #2 |
Gone Wild
Join Date: Oct 2012
Location: Southwestern Pa.
Posts: 6,215
|
Re: BMS and Alltrax settings for leafs?
My 14 cell Leaf pack BMS settings are as follows:
Max Pack charge = 57.0V (Note, this is 4.071V per cell) Max V per cell = 4.15 This will engage the HV relay and cut charging to the pack should any given cell exceed 4.15V. The max charge of a Leaf cell is 4.2V per cell. Anything over 4.2V per cell will damage the cell. Minimum V per cell = 3.14V Anything less will damage the cell!! 3.14V per cell = a pack V of 44V. BUT...when my pack Voltage gets to 50.0 it's time to STOP use and charge it. At 50.0V the pack (and each cell) is now at "The Knee" and will discharge to the minimum very rapidly. Also, as Sergio pointed out in my build thread, any cell that drops below 3.0V will have a very high risk of damage. Max and Min settings are crucial to having a long pack life, and preventing damage and thermal runaway of the pack. I don't think that can be emphasize enough nor overstated. I hope this helps. |
07-01-2021, 01:55 PM | #3 |
Gone Wild
Join Date: Apr 2017
Location: SE TN
Posts: 2,227
|
Re: BMS and Alltrax settings for leafs?
I also set my Max Battery Amps and Max Motor Amps to 300A. That's enough for any hill that I got, and I've got some big ones.
|
07-01-2021, 01:58 PM | #4 |
Gone Wild
Join Date: May 2012
Location: Rio Verde, Az
Posts: 7,193
|
Re: BMS and Alltrax settings for leafs?
I agree that 300 amps is a good max for most applications. It's still good IMO to buy the higher amp controller. I like having the cooling fan that comes on the Alltrax 500 amp controller. I play golf in hot weather and that fan kicks on often when I am driving in 100 degree temps.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Alltrax settings | Electric EZGO | |||
Got HD rear leafs, but less leafs than stock...should I exchange? | Electric EZGO | |||
Alltrax Settings | Electric Club Car | |||
Alltrax settings | Electric EZGO | |||
Alltrax settings | Extreme DC! |