|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
|
03-08-2014, 06:56 PM | #1 |
Not Yet Wild
Join Date: Feb 2014
Location: So Cal
Posts: 68
|
'98 CC Villager slows to a stop on hills
I picked up a '98 Villager (T9815) last week for darn near free. It's been sitting for years, but appears to be bone stock and 99% unmolested. Before I get too far involved with this thing, I wanted to make sure that there aren't any major issues. So here's my question: Why the heck won't this make it up a hill? I'd guess elevation climbs maybe 40'-50' in about 100 yds. Batteries are new and fully charged, BUT - they are 12v batteries wired up for the 48v that this cart is. I have a total of 6 batteries installed, 2 on the left, two in the middle, and two on the right. The left & right side pairs are connected in parallell, then in series to the remaining two in the center. I'm by no means an electrical genius, but this setup (I think), should work as well as a 6-8v setup for the short term testing that I'm doing. It seems fine on fairly flat ground (about 12mph). I don't think it's a battery issue, but correct me if I'm wrong. If not the batteries, what's the next most likely culprit? I'm suspecting F/R contacts worn/dirty, but I'm not sure if that would do it. I've seen a few threads here with the same issue I'm having, but nobody seems to fix the problem, or post about it if they do.
Second question is not a big deal for now, but what the heck, I'll toss it out there. The voltage reducer doesn't seem to be working correctly. It only seems to be reducing by about 2v. If I'm understanding correctly, fuse block gets connected to the full 48v, and the reducer drops it to 12v (or so) on the ground side. Is mine just bad, or I'm I wiring something wrong? Sorry for the long post, just trying to get the details in. |
03-08-2014, 08:10 PM | #2 |
Gone Wild
Join Date: Feb 2011
Location: Chattanooga TN
Posts: 2,105
|
Re: '98 CC Villager slows to a stop on hills
Your not using automotive batteries for your short term testing are you?
|
03-08-2014, 08:55 PM | #3 |
Not Yet Wild
Join Date: Feb 2014
Location: So Cal
Posts: 68
|
Re: '98 CC Villager slows to a stop on hills
|
03-08-2014, 09:08 PM | #4 |
Gone Wild
Join Date: Feb 2011
Location: Chattanooga TN
Posts: 2,105
|
Re: '98 CC Villager slows to a stop on hills
Ok 12mph sounds slow for flat land. Can you push the cart with one hand on flat level paved (like in drive way)land. Brakes or something else might be dragging.
|
03-08-2014, 09:22 PM | #5 |
Gone Wild
Join Date: Feb 2011
Location: Chattanooga TN
Posts: 2,105
|
Re: '98 CC Villager slows to a stop on hills
NAPA p/n 8240 is not a golf cart battery. Therefore your results may vary.
|
03-08-2014, 10:06 PM | #6 |
Gone Wild
Join Date: Feb 2011
Location: Homer, NY
Posts: 216
|
Re: '98 CC Villager slows to a stop on hills
Post a picture of your wiring. Something of good enough quality that we can make out the wiring.
Put a voltmeter across your pack. Tell us the voltage when still, and again when going up that hill. Any chance that voltage reducer is a 16v to 12v reducer, that you're hooking up to full pack voltage? And what is this "ground" you speak of? Don't hook your reducer to the cart frame, it needs to go to a battery terminal. Your pack wiring, if correct (like no battery in backwards or something), should work for your testing. But it won't charge correctly. So I wouldn't use this long-term. |
03-09-2014, 12:27 AM | #7 | ||
Not Yet Wild
Join Date: Feb 2014
Location: So Cal
Posts: 68
|
Re: '98 CC Villager slows to a stop on hills
Quote:
Quote:
I'm sure pack wiring is correct for everything that uses 48v. That's my main concern for now. Not really worried about charging at this point. I don't have a charger for it yet. I'm just using a couple of 24v chargers and splitting the pack in half when I need to charge. |
||
03-09-2014, 05:52 AM | #8 |
Medicare Recipient
Join Date: Jun 2011
Location: West Michigan
Posts: 3,541
|
Re: '98 CC Villager slows to a stop on hills
. . Villagers utilized a negative terminal block from factory . . . the lead should be running to the negative connection on the controller via the voltage limiter . . . if you look closer, you will probably find another negative terminal block near the passenger side dash area . . . the lighting system should have it's positive feed coming from the second battery in the pack, via a fuse block, because it is a 16-12v limiter . . . however, you do not have 8v batteries so there is no place to obtain 16v to feed the limiter . . . you have a few options . . .
1. . . connect your light switch positive feed (it comes from a fuse block that gets it's power from pack) to a 12v source in your pack and remove limiter from system but remember to connect negative terminal block to appropriate ground point (battery or controller) . . . 2. . . remove factory limiter (as it is probably useless with your battery configuration) and install a 48-12v reducer in it's place . . . 3. . . install the proper 6-8v battery configuration and utilize the factory 16-12v limiter . . . . . . as for the 8240 batteries, they are a cranking battery, not a battery designed for golf carts . . . |
03-09-2014, 11:08 AM | #9 |
Gone Wild
Join Date: Sep 2012
Location: Chestermere, Alberta - Canada
Posts: 1,146
|
Re: '98 CC Villager slows to a stop on hills
That NAPA battery is described on some websites as "excellent for starting and moderate deep cycle use" - nowhere near the kind of battery suitable for a golf cart's demand for power. If I understand his wiring description correctly - the two middle batteries are the weakest link- they are not being "helped" in parallel - so the current demand called upon to go up a hill is basically being pulled from them (their power will collapse first). The 48v setup described is fine for testing low loads and general cart operation - but its way too anemic to provide the amperage reserve for a hill climbing test.
There might be something else wrong with the cart - but until sufficent current is made available - we'll never really know. |
03-09-2014, 06:23 PM | #10 |
Not Yet Wild
Join Date: Feb 2014
Location: So Cal
Posts: 68
|
Re: '98 CC Villager slows to a stop on hills
Looks like I need to get some 8v batteries and go from there. Thanks for the responses. I'll update as soon as I can get my hands on the correct batteries.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
04 Villager slows to a crawl on type of any incline | Electric Club Car | |||
Slows On Hills. Please help. | Electric EZGO | |||
2002 Ezgo slows to stop on grade | Electric EZGO | |||
DS with Intermittent Power and Slows up hills | Electric Club Car | |||
After recharging, cart only briefly runs, then slows to stop | Electric EZGO |