EzGo Workhorse only runs up to 1/2 throttle then boggs.

Wasga · 11-26-2019, 10:28 AM

I have an EzGo workhorse with the robin eh35c engine. It will run fine at less than half throttle, but if you press more it will start to bog down. Let me tell you what i have done already. It has a new carburetor and is getting fuel from the fuel pump. I adjusted valves to specifications. (.004) I have done the HEI conversion, new coil and new pickup coil. I checked the timing belt to make sure it was in time. I have 175# compression on both cylinders. I am stumped with this thing. Does anyone have any input?

11-26-2019, 10:28 AM	#1
Wasga Not Yet Wild Join Date: Jun 2017 Posts: 6	EzGo Workhorse only runs up to 1/2 throttle then boggs. I have an EzGo workhorse with the robin eh35c engine. It will run fine at less than half throttle, but if you press more it will start to bog down. Let me tell you what i have done already. It has a new carburetor and is getting fuel from the fuel pump. I adjusted valves to specifications. (.004) I have done the HEI conversion, new coil and new pickup coil. I checked the timing belt to make sure it was in time. I have 175# compression on both cylinders. I am stumped with this thing. Does anyone have any input?
Wasga Not Yet Wild Join Date: Jun 2017 Posts: 6

Similar Threads
Thread	Forum
WTB ezgo engine cradle and rear end for workhorse	Golf Carts and Parts
I need Engine craddle dimensions for ezgo workhorse 1200	Clone Engine Swaps
Workhorse Engine Problem	Gas EZGO
EZGO Workhorse Honda V Twin engine swap	Big Block Talk!