|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
03-20-2016, 11:28 AM | #31 |
Gone Wild
Join Date: Sep 2015
Location: San Antonio, TX
Posts: 260
|
Re: So I put the motor back in....
Ok I got it back from the shop. It runs great. I do need to take the secondary clutch off again and clean it because it's stuck open again after being left out with rain and what not and need a shorter starter belt. Turns out it was the starter/generator. The mechanic there was an older guy that seemed to love these old carts. He was telling me how tough these little G1s are and that someone brought one in that was caught in a flood and was under 10 ft of water. He had to change the spark plug and put in new gas and it fired right up. It was cool to see someone that had an appreciation for these carts. No one else wanted to touch it. He pretty much put it all back together correctly for me even down to the reverse noise that wasn't there before and even washed it and cleaned up the seats. I should have gotten his info incase I needed anything done on the side.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-20-2016, 07:54 PM | #32 |
Gone Wild
Join Date: Sep 2015
Location: San Antonio, TX
Posts: 260
|
Re: So I put the motor back in....
Just ran it all over the neighborhood. GPS clocked it at around 18mph top and around 16mph consistently. A it normal for it to actually slow itself once it gets going too fast? Once it hits that 17mph it just will not do any more even going downhill. Going uphill makes it really seems to move. Is that just the governor doing that?
|
03-25-2016, 09:30 PM | #33 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: So I put the motor back in....
Just the governor, all is normal. If you are using a stock belt, and think a shorter belt will solve clutch problems, you will be disappointed with the results. The G1 belt is already a tight setup anyway, a shorter belt will be really hard to install, and will hurt performance.
|
03-27-2016, 02:49 PM | #34 | |
Gone Wild
Join Date: Sep 2015
Location: San Antonio, TX
Posts: 260
|
Re: So I put the motor back in....
Quote:
|
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Got my motor back from PQ | Electric Club Car | |||
pq motor is back and in !!! | Electric EZGO | |||
Putting the two halves of the motor back together | Gas EZGO | |||
1988 Parcar..I'm back..with useless motor. | Gas Columbia ParCar | |||
G1 Motor-what are these on the back of the block | Gas Yamaha |