|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
03-28-2021, 03:17 PM | #1 |
Not Yet Wild
Join Date: Mar 2021
Posts: 6
|
Ezgo cart will not move
My cart will not move after shorting out two prongs on charging port while changing. Solenoid not clicking so installed new solenoid still no clicking or cart movement. I am getting 48v on both small terminals on Solenoid as soon as I turn key switch to on position, and from what I have read you shouldn't get 48v until you pres the gas pedal. Thx
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-28-2021, 04:53 PM | #2 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Ezgo cart will not move
You didn't mention which of the drive types (Series, Sepex or AC) you cart has, but with some of them you get battery pack voltage (B+) to the solenoid coil when the key is turned on (along with some other things) and pushing the pedal applies B- to the other side. With those drive types, before the pedal is pushed, you will measure pack voltage on both small terminals.
What type drive does your cart have? |
03-28-2021, 06:53 PM | #3 |
Not Yet Wild
Join Date: Mar 2021
Posts: 6
|
Re: Ezgo cart will not move
I not sure what type it is. Its a 2010 txt looking on internet they say its a DC.
|
03-28-2021, 07:27 PM | #4 |
Not Yet Wild
Join Date: Mar 2021
Posts: 5
|
Re: Ezgo cart will not move
Make sure the wires are good and all wires are connected and batteries are up to date, I know this states the obvious but my old cart did this a few years ago and the wires were not connected correctly
|
03-28-2021, 07:29 PM | #5 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Ezgo cart will not move
Quote:
See attached chart. |
|
03-29-2021, 12:28 PM | #6 |
Not Yet Wild
Join Date: Mar 2021
Posts: 6
|
Re: Ezgo cart will not move
Yeah I'm thinking maybe blue wire that comes from charging port to the solenoid may have shorted out when I arched out the two prongs on charging port. Cause now when I plug charger in I get a fault. Batteries are brand new.
|
03-29-2021, 02:11 PM | #7 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Ezgo cart will not move
Sounds like you need to replace the charging port.
|
03-30-2021, 05:24 PM | #8 |
Not Yet Wild
Join Date: Mar 2021
Posts: 6
|
Re: Ezgo cart will not move
I have already replaced it, can the resistor on the solenoid be the issue I get a 4v difference from the battery side to the controller side I read that you shouldn't get more than 3 or the resistor is bad.Any thoughts on this.
|
03-30-2021, 07:24 PM | #9 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Ezgo cart will not move
Quote:
Also the voltage source fro the blue wire might have been whacked. A 4V drop across the solenoid's large terminals is close enough. |
|
03-30-2021, 08:01 PM | #10 |
Not Yet Wild
Join Date: Mar 2021
Posts: 6
|
Re: Ezgo cart will not move
I shorted out the old charging port not the new one. Where does the blue wire get voltage from?
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
96' ezgo txt dcs cart will not move | Electric EZGO | |||
Ezgo Series cart will not move | Electric EZGO | |||
EZGO wont move (first cart) | Electric EZGO | |||
EZGO cart 36v will move about 3 inches thats it. | Electric EZGO | |||
EZGO DCS Cart won't Move | Electric EZGO |