Need help ezgo txt dcs

toxicwaste29 · 03-01-2021, 08:12 PM

Have an ezgo dcs that had an upgraded motor, axe controller, and the original fnr mechanism. Cart would click but not move. Upgraded the fnr mechanism to scotty's kit however cart would still click and not move. I bought a new fsip controller and cart still clicks won't move.

For the its the white wire never drops below 10v with the pedal all the way down. Wiring is intact and ohms okay through the entire cart. Pedal clicks solenoid just won't move. Motor tests okay. Batt pack is okay.

IDK where else to look now and don't want to throw any more money at this cart.

toxicwaste29 · 03-01-2021, 08:15 PM

Picture of the controller with the its hooked up

JohnnieB · 03-02-2021, 01:35 PM

A DCS is a Sepex drive, so the cart isn't a DCS or someone has converted it to a series drive.

Are you sure the controller is compatible with an ITS throttle? (Controllers used with pot-box throttle look the same.)

toxicwaste29 · 03-03-2021, 09:16 PM

Sorry it's a series cart. Called fsip and they forgot to send me a its convertor. I installed that and the cart is still doing nothing. Wire wire voltage now goes from 0.5 to 1.8 full throttle

03-01-2021, 08:12 PM	#1
toxicwaste29 Gone Wild Join Date: Aug 2014 Location: Akron, Ohio Posts: 189	Need help ezgo txt dcs Have an ezgo dcs that had an upgraded motor, axe controller, and the original fnr mechanism. Cart would click but not move. Upgraded the fnr mechanism to scotty's kit however cart would still click and not move. I bought a new fsip controller and cart still clicks won't move. For the its the white wire never drops below 10v with the pedal all the way down. Wiring is intact and ohms okay through the entire cart. Pedal clicks solenoid just won't move. Motor tests okay. Batt pack is okay. IDK where else to look now and don't want to throw any more money at this cart.

03-02-2021, 01:35 PM	#3
JohnnieB Techno-Nerd Join Date: Jun 2011 Location: West Virginia Posts: 19,654	Re: Need help ezgo txt dcs A DCS is a Sepex drive, so the cart isn't a DCS or someone has converted it to a series drive. Are you sure the controller is compatible with an ITS throttle? (Controllers used with pot-box throttle look the same.)

03-03-2021, 09:16 PM	#4
toxicwaste29 Gone Wild Join Date: Aug 2014 Location: Akron, Ohio Posts: 189	Re: Need help ezgo txt dcs Sorry it's a series cart. Called fsip and they forgot to send me a its convertor. I installed that and the cart is still doing nothing. Wire wire voltage now goes from 0.5 to 1.8 full throttle

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum