![]() |
|
Gas golf carts Harley Davidson, Melex, Pargo, Taylor-Dunn and other Misc. Carts. |
![]() ![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Gone Wild
![]() Join Date: Aug 2007
Location: North Texas
Posts: 2,314
|
![]() Broken or stripped studs on a primary clutch can be repaired if you have a drill press and welder. A parts supplier said the clutch was beyond repair but the face was not worn and was expensive to replace. I welded a jig to hold the clutch in the proper position for drilling and drilled through the bad stud with a pilot drill then drilled and tapped for 1/4-28. I should have cut off the damaged stud then found the center and drilled. (more accurate method) I used 1/4-28 grade 5 bolts and cut to length then fixed with red loctite. I could have used 1/4-28 set screws as well. I made the jig in the photo so I could turn the bad stud over the base offset for stability. An added brace under the stud and slow drilling is in order. With care a very good repair like this can save cash.
|
![]() |
![]() |
![]() |
|
![]() __________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
![]() |
#2 |
What the ....?
![]() ![]() Join Date: Jan 2007
Location: Hemingway, S.C.
Posts: 15,251
|
![]() Nice fix! Stickied!
![]() |
![]() |
![]() |
![]() |
#3 |
Not Yet Wild
![]() Join Date: Aug 2018
Location: ohio
Posts: 13
|
![]() if those studs are screwed in, especially into aluminum, I never use a drill or drill them out. I always go for the welder.
|
![]() |
![]() |
![]() |
|
Thread Tools | |
Display Modes | |
|
![]() |
||||
Thread | Forum | |||
HD clutch repair | Gas Harley Davidson | |||
clutch stud repair | Gas Harley Davidson | |||
1989 clutch repair | Gas EZGO | |||
clutch is shot i think. any way to repair? | Gas Yamaha | |||
clutch repair ezgo | Gas EZGO |