Curtis Controller 1204-015 to 1204-017

[fairguy]

Hey guys, I have a 1993 Club Car DS Solid State drive with a bad Curtis 1204-015 controller. I found an upgraded 1204-017 (upgraded to 400 Amp). Will they interchange?

[jakesnake27]

Yep, they will interchange.

Just know that you need at least 4 gauge cables to run a 400 amp controller.

[krko180]

Would this model of controller work on my 96 club car ds 48 volt with a Curtis 1204-410 stock one[


Sent from my iPhone using Tapatalk

[jakesnake27]

Originally Posted by krko180

Would this model of controller work on my 96 club car ds 48 volt with a Curtis 1204-410 stock one

You need a 5k-0 throttle input, but that controller is programmable, so the throttle type should be able to be changed. You'd have to find someone with a Curtis programmer, however.

I'd recommend just getting an Alltrax SR.

[fairguy]

Originally Posted by jakesnake27

Yep, they will interchange.

Just know that you need at least 4 gauge cables to run a 400 amp controller.

I have 2 gauge cables. I put the controller on & it runs like a banshee!! Thanks to all!

[jakesnake27]

[krko180]

Ok got my cart running 5.5hp Ge motor axe 4845 controller 400 amps,heavy duty solenoid,2/0 cables on everything.should my cables be getting pretty warm going to the front of my forward reverse switch cause every cable other than these stay cold. I have a heavy duty forward reverse switch to put on yet had to modify my old one to except larger cables.


Sent from my iPhone using Tapatalk