Carryall 6 No Start**Help**

[big mule]

Bought a 2000 Carryall 6 key start cart that cranked as it should but now it will do nothing when the key is turned on & to the start position,I'm an Ezgo guy and not very strong in Club Car electrical trouble shooting .It has the 6 pin relay in the electrical box,starter solenoid & fuse box with 3 fuses installed but does not have the micro switch in there (just like it was when I got it & was cranking fine without it) & I see there's a diode hooked between the small posts of the solenoid.I did check and the charging system is only putting out a little over 12 volts,how can I confirm that the solenoid,the diode,key switch & voltage regulator is good or bad?I can "jump" from the starter side (white cable) to the positive battery post or between the solenoid big posts and it will fire right up and is drivable after removing the jumper wire.Thanks for any help & tips on figuring this out or wiring around all this .

[buggyAl]

Glad you are starting to see the other side. Is the cart in "maintenance" mode? This switch is behind the F/R lever under the seat. If in the "run" mode the cart needs to be in gear (F or R) to run. Try with this. A short cut that I use on my VI is to dis-connect the black & white wire from the relay in the throttle box (black box) under the carb next to the battery.

[big mule]

Thanks I'll give that a try .