Primary drive sleeve

[Myyke]

Hi folks,
Anyone happen to know the outer diameter for the needle bearing sleeve on the primary drive?

I found the bearing & seals i need, but i need to build a sleeve.

Thanks in advance.

[Scooter_Trash]

Originally Posted by Myyke

Hi folks,
Anyone happen to know the outer diameter for the needle bearing sleeve on the primary drive?

I found the bearing & seals i need, but i need to build a sleeve.

Thanks in advance.

Got a part number Mike?

[Myyke]

Originally Posted by Scooter_Trash

Got a part number Mike?

No not yet. I’ll have to look in my parts manual. Thanks

[Myyke]

Originally Posted by Scooter_Trash

Got a part number Mike?

So here is the info i’ve been able to find.

In the 1963-80 gas manual:
Sec 4 pg 4, figure 4b-43. #20a needle bearing, late 64( looking for the sleeve on the outside)

In the 1963-81 gs parts book i have:
Page 9, part 29 in pic,
Part#’s are:
36462-64 needle bearing sleeve assembly (64 to 66)
36462-67 (67 to present)

If i could find just the outside sleeve dimensions or drawing i could build my own.

[Scooter_Trash]

Originally Posted by Myyke

So here is the info i’ve been able to find.

In the 1963-80 gas manual:
Sec 4 pg 4, figure 4b-43. #20a needle bearing, late 64( looking for the sleeve on the outside)

In the 1963-81 gs parts book i have:
Page 9, part 29 in pic,
Part#’s are:
36462-64 needle bearing sleeve assembly (64 to 66)
36462-67 (67 to present)

If i could find just the outside sleeve dimensions or drawing i could build my own.

the 36462-64 sleeve is:
.78" L
1.5" OD
1.368 ID (difficult for me to measure, so your bearing OD should dictate)
In case you don't have an old one, I'll note that this sleeve captures the bearing between two oil seals.
Good Luck!

[Myyke]

Originally Posted by Scooter_Trash

the 36462-64 sleeve is:
.78" L
1.5" OD
1.368 ID (difficult for me to measure, so your bearing OD should dictate)
In case you don't have an old one, I'll note that this sleeve captures the bearing between two oil seals.
Good Luck!

Exactly what i was looking for. Thank you very much.
Looks like the seals are backwards to what i usually see on other things. Wasn’t sure which way they went in.
Thanks again.

Here is what i was able to find for bearings & seals according to the inner race i had.
Seal: National brand pt# 340815
Bearing: BA188Z

[Scooter_Trash]

Originally Posted by Myyke

Exactly what i was looking for. Thank you very much.
Looks like the seals are backwards to what i usually see on other things. Wasn’t sure which way they went in.
Thanks again.

Here is what i was able to find for bearings & seals according to the inner race i had.
Seal: National brand pt# 340815
Bearing: BA188Z

Thanks for posting the cross refs.
The seal on the opposite side is ALSO inserted opposite, so both seals face in the same direction.

[Leon willis]

Inch and a 1/2 been a minute since I had my cart apart so don’t quote me sorry