|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
01-10-2014, 10:42 PM | #1 |
Not Yet Wild
Join Date: Jun 2013
Location: Michigan
Posts: 44
|
G16 flywheel puller size
Wanted to rebuild my motor and going to buy a Flywheel 3 jaw puller ..what size 3 jaw puller should I buy..thinking a 8 inch will work ..help plz
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-10-2014, 11:20 PM | #2 |
Not Yet Wild
Join Date: Jun 2013
Location: Michigan
Posts: 44
|
Re: G16 flywheel puller size
Can anyone tell me the approximate size of a flywheel on a G16..that would help greatly Thanks
|
01-11-2014, 09:47 AM | #3 |
Gone Wild
Join Date: Sep 2010
Location: Erie, Pennsylvania
Posts: 989
|
Re: G16 flywheel puller size
I'm not 100% sure for the G16, but I don't think you want a "jaw" type puller for the flywheel. The factory sometimes provides two or three tapped holes in the flywheel and you then use a steering wheel type puller along with the proper bolts in the tapped holes. I'll check my G16 repair manual to see if it shows how. I'll let you know if I find it. If you are planning a rebuild I would think a repair manual should be your first purchase. Good luck - RAY
|
01-11-2014, 01:17 PM | #4 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: G16 flywheel puller size
NO JAW PULLER! I have broken a flywheel that way. There should be three bosses around the center shaft, sometimes drilled/tapped, sometimes not. If not, drill / tap it, then use a slotted wheel puller as said above.
|
01-11-2014, 01:24 PM | #5 |
Not Yet Wild
Join Date: Jun 2013
Location: Michigan
Posts: 44
|
Re: G16 flywheel puller size
ok thank you for your help ..well appreciated
|
01-11-2014, 02:57 PM | #6 |
Sometime's............
Join Date: Oct 2007
Location: Tacoma Washington
Posts: 11,868
|
Re: G16 flywheel puller size
Don't chastize me guy's.....Yamaha service manual calls for a 2 or 3 jaw puller. I've had good sucsess with the nut and lock washer removed, reinstall the nut flush with the crank threads and use a "dead blow" hammer with a good "rap". This must be done only after the rod/piston assy has been removed! Why they didn't have drilled/tapped holes is a mystery to me. Good luck on your rebuild!
|
01-11-2014, 07:39 PM | #7 |
Gone Wild
Join Date: Sep 2010
Location: Erie, Pennsylvania
Posts: 989
|
Re: G16 flywheel puller size
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
79 Ezgo needs Flywheel puller (Where do I find one??) | Gas EZGO | |||
flywheel puller | Gas Harley Davidson | |||
flywheel puller tool | Gas EZGO | |||
G1 flywheel puller | Gas Yamaha | |||
flywheel puller ---- cant get flywheel off! | Gas Harley Davidson |