03-09-2022, 11:34 AM | #1 |
Not Yet Wild
Join Date: Sep 2020
Location: Spring, TX
Posts: 6
|
Code 1,3 showing on controller
Good day ALL, need some assistance. I have a 2010 Tomberlin E-Merge 500. I have read several threads here on the 1,3 code for speed sensor fault. We have not used the cart for several months and it has stayed plugged in on the charger. I did notice charger was not charging one day after a power surge in the house and looks like it took out my charger. Batteries did drop to 38 volts, got new charger and batteries are back up and pack is at 50.8 volts and holding and each battery is holding at 8.4 volts also checked each cell with hydrometer and all test good, so batteries are good. I took it out and went to accelerate and took off but quickly dropped to 2 mph. That is when I checked controller and saw the 1,3 blinks. Had new motor installed 2 years ago, I checked the speed controller, unplugged it and connector looked fine plugged it back in and heard a clicking noise once plugged back in. Code went away until I went and drove it. Not sure if I am over thinking this and should just replace speed sensor and go from there. I do not have a Tomberlin dealer any where near me so can't have it scanned. Any assistance is greatly appreciated!
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-10-2022, 07:16 AM | #2 |
Gone Wild
Join Date: Sep 2020
Location: Germany
Posts: 1,999
|
Re: Code 1,3 showing on controller
Flashing Code 1,3 points to the speedsensor. Maybe bad contact? Easy test, if the speedsensor is working, push the cart forth and back by hand and you should hear a click and feel resistance from the motorbrake. If so, speedsensor is working. To replace the sensor, a Clubcar DS sensor works fine and is much cheaper than the Tomberlin part.
|
03-10-2022, 12:24 PM | #3 |
Not Yet Wild
Join Date: Sep 2020
Location: Spring, TX
Posts: 6
|
Re: Code 1,3 showing on controller
Thank you very much for responding! I will give that a try and see what happens
|
03-10-2022, 04:38 PM | #4 |
Not Yet Wild
Join Date: Sep 2020
Location: Spring, TX
Posts: 6
|
Re: Code 1,3 showing on controller
I did the back and forth movement and did not hear any clicks and there was no resistance at all. I ordered the new speed sensor and will hope that is it. Thank you again!
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Controller Code 39 - Please Help | Electric EZGO | |||
Curtis 1264 - 5407 controller showing 2-4 | Electric EZGO | |||
Ezgo LSV Curtis SepEx controller , 1st code 24, now gone, only code 34 now. | Electric EZGO | |||
Controller with speed code 4 | Electric Club Car | |||
IQ controller w/speed code 4 | Golf Carts and Parts |