|
Big Block Talk! Everything about swapping a big block engine into your cart! |
|
Thread Tools | Display Modes |
11-25-2022, 06:39 PM | #11 |
Not Yet Wild
Join Date: Nov 2022
Location: Michigan
Posts: 69
|
Re: Hooking throttle direct question
Ok I found my problem. I jacked up the read end and I have something causing drag on the drivers side. I took off the wheel and wheel spacer and then no drag. If I put on a couple lugs and tighten them had tight I get bad drag again. So now to figure that out.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
11-28-2022, 11:08 PM | #12 | |
Searching for The Way
Join Date: Oct 2009
Location: Medina, Ohio (NEOHIO)
Posts: 11,421
|
Re: Hooking throttle direct question
Quote:
|
|
11-29-2022, 09:15 AM | #13 |
Not Yet Wild
Join Date: Nov 2022
Location: Michigan
Posts: 69
|
Re: Hooking throttle direct question
It did not change anything with the RPM issue. It did however make take off and acceleration much better. And from what I am told my top speed of 22-23 mph at 3k rpm is what it should be.
Now i haven't investigated this, kinda thought of it on the way to work. If my Primary and secondary clutches have too soft of springs in them, would that cause the RPM issue? Like it is gearing out too fast for lack of better terms?? |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
EZGO Direct Replacement Tie Rods Question | Electric EZGO | |||
Question about hooking up LED lights to a gas cart | Gas Yamaha | |||
G22 direct throttle cable. | Gas Yamaha | |||
Hooking a 16hp Briggs throttle to CC rear end governor??? | Big Block Talk! |