|
|
|||||||
| Gas golf carts Harley Davidson, Melex, Pargo, Taylor-Dunn and other Misc. Carts. |
  |
|
|
Thread Tools | Display Modes |
05-26-2020, 08:30 PM
|
#1 |
|
Not Yet Wild
Join Date: May 2020
Location: Woodstock, IL
Posts: 5
|
Oil seal install
Ok, putting the whole engine back together... Do you guys put any sort of sealant around the outside edge of the oil seals on the crank? I read somewhere that red loctite sealant was good... Last crank seals I did (78 John Deer Spitfire), I only greased the inner seal and left the outer rim alone... Seemed to work fine...
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
05-27-2020, 09:27 AM
|
#2 |
|
Gone Wild
Join Date: May 2011
Location: Pittsburgh
Posts: 2,944
|
Re: Oil seal install
I have always just put them as is. I would be hesitant to put anything on them. I would be fearful that loctite would make getting them off a challenge should it ever need done in the future. Likewise, any grease or lube could help them pop off under load which actually happened to me once.
|
|
|
|
|
05-27-2020, 07:56 PM
|
#3 |
|
Not Yet Wild
Join Date: May 2020
Location: Woodstock, IL
Posts: 5
|
Re: Oil seal install
Thanks Lochlin... Hopefully, this is a one-time job for me! :)
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Bad seal | Gas Harley Davidson | |||
| EZGO Headlight install - new install not working | Electric EZGO | |||
| Hub seal | Electric EZGO | |||
| Install 6" all sport lift kit trouble install steering linkage | Lifted Golf Carts | |||
| crankshaft seal install method | Gas Yamaha | |||
Linear Mode
