![]() |
![]() |
#1 |
Getting Wild
![]() ![]() Join Date: Oct 2016
Location: Gleniffer Lake Resort ALBERTA Canada
Posts: 128
|
![]() I just finished fixing a burnt ground in my 2007 Fairplay XL . The #1 ground wire in the ten pin connector overheated and burnt the controller pin. There was a #10 gauge ground wire that had somehow been taken off the main negative and slid down between the batteries. I soldered a terminal onto the burnt pin and reconnected everything.
THE CART RUNS !!! It goes both ways but now i have a different problem. When you push the throttle past half way the reverse beeper goes off and it won’t go in either direction. I have to toggle the tow/ run switch then it will run again until i push the throttle too far. I tried disconnecting the speed sensor but there was NO DIFFERENCE. Any ideas |
![]() |
![]() |
|
Thread Tools | |
Display Modes | |
|
![]() |
||||
Thread | Forum | |||
Pds 36v runs slow....reverse then forward runs normal | Electric EZGO | |||
Cart runs fine until I stop then runs very slow | Electric EZGO | |||
Runs slow | Electric Club Car | |||
2006 PDS runs good then runs slow | Electric EZGO | |||
82 club car, runs slow if you press pedal easy, runs normal if you hit it hard? | Electric Club Car |