|
On Road Golf Carts! Low to the ground Golf Carts! |
|
Thread Tools | Display Modes |
07-11-2012, 08:37 AM | #1 |
Not Yet Wild
Join Date: Jul 2012
Location: Daphne, AL
Posts: 13
|
Lowering a gas EZ go txt
I see a lot of threads for lowered carts, but all I have a seen are electrics. Has anyone lowered a gas EZ go? I'm going to look at one this afternoon that has a blown engine, and while i was at it I was going to lower it, is there some reason that this is not feasible/practical for a gas cart?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-29-2012, 07:48 PM | #2 |
Gone Wild
Join Date: Nov 2008
Location: Montgomery, AL
Posts: 1,463
|
Re: Lowering a gas EZ go txt
the eng will hit the seat bottom. there is only about 2-3" clearance now.
|
07-29-2012, 09:01 PM | #3 |
I Refuse To Get Stuck!!!
Join Date: Jun 2010
Location: Hilton,NY
Posts: 5,427
|
Re: Lowering a gas EZ go txt
If you are decent at fabrication,drop the engine-cradle down thru the swing-arm a few inches(measure and see howmuch you can drop it,without it bottoming before the swing-arm).Then lower the cart 3".You can make blocks for the front and rear springs,since the rear axle is over the springs,and the front has the springs under as well.Hope this helps.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Lowering a g2/g9? | Gas Yamaha | |||
lowering mt txt | Electric EZGO | |||
lowering | On Road Golf Carts! | |||
lowering | Design Center | |||
lowering an ez go? | Design Center |