EZ GO 600CBR 6 Speed gearing question.

[MORE_GUNS]

Hello everyone. This is my first post so thanks everyone in advance. I just bought a completed 94 EZ GO with a fuel injected 600 cbr engine and 6 speed transmission. This setup was built using the original sprockets off the bike with a live axle. I am going to use this for a sporting clays cart. I am wanting to get this cart geared as short as possible so I can keep 1st gear as slow as possible to haul 4 guys around the course. Does anyone have any suggestions on sproket sizes to get the lowest possible gearing?? I really appreciate the input. Thanks!!!!

[rifter]

Smallest front and biggest rear sprockets you can get will lower the gear ratio, I ran a 13 and a 60

[Bourkeyuk]

Hi I’ve used standard CBR front and rear sprockets and it’s spot on atm I’ll find out more once I’ve had a good long drive but it’s a decent starting point

[rifter]

I have a stack of sprockets, hubs, from working to figure out what ratio works for Drag Racing, I got the best combination for my engine and axle,,, as far as driving around the Park or neighborhood, good luck with what ever atm is.

[Sh00bs]

Originally Posted by rifter

I have a stack of sprockets, hubs, from working to figure out what ratio works for Drag Racing, I got the best combination for my engine and axle,,, as far as driving around the Park or neighborhood, good luck with what ever atm is.

atm =

at the moment :)