03-28-2013, 07:05 AM | #1 |
Not Yet Wild
Join Date: Oct 2012
Posts: 6
|
Cowl Strip/Trim
I have an 87 Club Car DS and am in the re-assembly phase of my project. (good thing I have lots of assembly fluid Anyways, the strip that goes across the cowl has some short screws that hold it in place but I can''t find the proper screw to go into the "T-nuts" It appears to be a #8 but the threads seems a little coarser(sp?) than a regular 8-32. I have not been able to find an 8-24 - does anyone know what size these screws are?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-28-2013, 09:56 AM | #2 |
Medicare Recipient
Join Date: Jun 2011
Location: West Michigan
Posts: 3,541
|
Re: Cowl Strip/Trim
8-32 x 3/8 . . . seems to be the common size over the years . . .
|
03-28-2013, 12:22 PM | #3 |
Not Yet Wild
Join Date: Oct 2012
Posts: 6
|
Re: Cowl Strip/Trim
Thanks, I did have it powder coated so I'll run the tap through it
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Best Way To Painting Trim On CC | Body and Paint | |||
What causes Yamaha G16s to strip cam gears? | Gas Yamaha | |||
G9 Cowl / plastic swap. Which Cowl do I buy? | Gas Yamaha | |||
New Drag Strip in Orlando | Golf Cart Racing | |||
did I strip a gear in rear axle? | Electric EZGO |