|
|
|||||||
| Big Block Talk! Everything about swapping a big block engine into your cart! |
  |
|
|
Thread Tools | Display Modes |
07-03-2007, 07:12 PM
|
#1 |
|
Frog Hunter
Join Date: Dec 2006
Location: Little Rock, Ar
Posts: 1,161
|
Cutch Puller
I got one for the cart and i cant seem th figure out how it works...Thanks
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
07-03-2007, 07:28 PM
|
#2 |
|
Gone Wild
Join Date: Dec 2006
Location: ComplainAboutNoNo'sProfile-Ville
Posts: 4,995
|
Re: Cutch Puller
For the stock Club Car clutch, you remove the bolt; insert the long end of the puller into the hole until it won't go in any more; thread in the screw/bolt type device on the puller shaft; tighten the screw/bolt thing until the clutch pops loose. I usually turn it a turn, and give it a light tap with a hammer, turn, tap....
I'm not sure if that's the kind you have, so you may want to post a picture. |
|
|
|
|
07-03-2007, 07:58 PM
|
#3 |
|
Frog Hunter
Join Date: Dec 2006
Location: Little Rock, Ar
Posts: 1,161
|
Re: Cutch Puller
|
|
|
|
|
07-03-2007, 08:01 PM
|
#4 |
|
Gone Wild
Join Date: Dec 2006
Location: ComplainAboutNoNo'sProfile-Ville
Posts: 4,995
|
Re: Cutch Puller
That is the same principle.
 |
|
|
|
|
07-03-2007, 10:05 PM
|
#5 |
|
Frog Hunter
Join Date: Dec 2006
Location: Little Rock, Ar
Posts: 1,161
|
Re: Cutch Puller
Thats what I thoughm, but the part that goes down in the shaft was way too long, so i used a drill bit, worked great, its on the new briggs!
|
|
|
|
|
07-04-2007, 09:44 AM
|
#6 |
|
Gone Wild
Join Date: Dec 2006
Location: ComplainAboutNoNo'sProfile-Ville
Posts: 4,995
|
Re: Cutch Puller
COOL! Good job! Now you should be on your way.
 |
|
|
|
Linear Mode
