2010 Tomberline emerge

[mordo]

I just received a 2010 timberline emerge and it won't go. Charged batteries everything is working lights, upper fan reverse buzzer comes on but it won't move.

After charging for a couple days it went in reverse about 100 yards and quite.


Any suggestions?

[Golf cart guy]

The easiest way to find the issue is to have someone scan it. OR look at the front of the controller and see what the light is flashing, to figure out what the code is.

[dcannow]

Originally Posted by mordo

I just received a 2010 timberline emerge and it won't go. Charged batteries everything is working lights, upper fan reverse buzzer comes on but it won't move.

After charging for a couple days it went in reverse about 100 yards and quite.


Any suggestions?

IT'S A TOMBERLIN ---Be sure the parking brake is released. Take the screws out of the brake boot and you will see a switch below the brake handle. put a folded piece of cardboard (1/4 inch) between the brake handle tab and the switch. This is a kill switch to prevent running with parking brake on. If cart will now move readjust the switch holding bolts to get the switch shaft higher. Or, better yet bend the brake handle tab down a little. But if still no movement come back on the forum

[mordo]

Took it to repair shop they replaced the solenoid no help now they are replacing the speed control I thinking they are just buying parts will address the codes on controller and the parking brake issue.

Thanks for input will update this afternoon

[Golf cart guy]

The last thing you want is a shop guessing and part swapping. A good shop would scan the codes first. Time for a new shop

[mordo]

Shop did not change speed control currently codes

1 flash pause then 5 flashes

[JimVA]

Manual may help ...
http://mobiletomberlin.net/downloads...010-2011-1.pdf

See Chapter 10, page 17. 1 flash then 5 flashes appears to mean Motor Failure.

Let us know what you find out. Good luck.

[Bronco Barney]

pics?

[mordo]

The story keeps coming dealer found front brake lock, broke lose now code shows overheated probably because of the lock hub. Disconnect the motor and tested motor is good. Change speed sensor its ok so put old one back in going to try and replace Hall effect sensor as someone has suggested in forum. Hopefully we get this baby running soon enough quite the learning experience.

[mordo]

Once you fix and existing problem how to your reset the control to check for new codes?