|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
09-27-2016, 07:47 PM | #1 |
Getting Wild
Join Date: Jul 2015
Posts: 146
|
precedent started then stopped several times today
2011 club car started and then stopped and then started rolling again several times today. It did it again tonight. I turned the key switch off and the curtiss volt meter light only dimmed instead of going out like normal. I turned the run/tow switch off and back on again and the cart ran like normal again. Ideas/suggestions? All mods done are in my sig line. Cart has been running excellent until tonight.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-28-2016, 07:35 PM | #2 |
Getting Wild
Join Date: Jul 2015
Posts: 146
|
Re: precedent started then stopped several times today
Anybody?
|
09-28-2016, 07:39 PM | #3 |
Old Sky Soldier
Join Date: Dec 2011
Location: Kentucky
Posts: 3,881
|
Re: precedent started then stopped several times today
Wire loose on key switch.
|
09-28-2016, 07:50 PM | #4 |
Gone Wild
Join Date: Aug 2009
Posts: 14,245
|
Re: precedent started then stopped several times today
Or even a faulty key switch
|
09-28-2016, 08:07 PM | #5 |
Getting Wild
Join Date: Jul 2015
Posts: 146
|
Re: precedent started then stopped several times today
just got home a few minutes ago but the key switch crossed my mind about being bad, however, the thing about it not running until I cycled the run/tow switch kind of throws me.
|
09-28-2016, 08:42 PM | #6 |
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: precedent started then stopped several times today
The KSI SRO fault, which means the controller sensed the Key already ON when the logic power (Tow/Run) was sensed, would have required a Tow/Run power cycle.
Did You get any error blinks on the Controller? Check the 16-pin to 24-pin adapter is fully inserted, the controller connectors are seated and the Tow/Run switch connections are good as well. |
09-28-2016, 09:18 PM | #7 |
Getting Wild
Join Date: Jul 2015
Posts: 146
|
Re: precedent started then stopped several times today
thanks! I will check all of this tomorrow when I get home from work. Hopefully it will not be as long as this one was today.
|
09-28-2016, 09:25 PM | #8 |
Getting Wild
Join Date: Jul 2015
Posts: 146
|
Re: precedent started then stopped several times today
sergio, i just looked up that KSI SRO in the 1268 manual. Would a bad switch or loose wire from/on the switch cause that and why cycling the tow/run switch let me go again?
|
09-28-2016, 09:40 PM | #9 |
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: precedent started then stopped several times today
If any of those connections I mentioned was loose and caused the "Logic Power" pin on the controller 24-pin connector to "bounce" while the Key switch was ON, it would have activated that fault until You repeated the Power ON sequence with the Key OFF.
I cannot think of any other "Critical Error" that would require a Tow/Run cycle. Definitively look for blinking error codes on the Controller (before You put it on Tow) if You have the problem again. |
|
|
Similar Threads | ||||
Thread | Forum | |||
08 Precedent alltrax controller blinking 5 times | Electric Club Car | |||
Started Building 3 link Rear suspension today... | Design Center | |||
EZGO DCS stopped working, then started back?? | Electric EZGO | |||
how many times does my 07 precedent fire per revolution | Gas Club Car |