|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
05-27-2023, 04:14 PM | #1 |
Not Yet Wild
Join Date: May 2023
Location: Bonneau Beach
Posts: 10
|
Accelerator has little low range
I upgraded my dc cc ds with a Navitas 5kw kit and replaced the factory wiring harness with a 3900 wiring harness. Now that the cart runs so much faster there is little to no range on the accelerator. You have to press the pedal almost to full before you start to move. So there is very little low range which makes it very jerky. The cart currently has a generic MCOR1 but I have the MCOR4 conversion kit on the way.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-27-2023, 05:33 PM | #2 |
Gone Wild
Join Date: Apr 2020
Location: Hurricane, Utah
Posts: 2,797
|
Re: Accelerator has little low range
The new MCOR may fix that but also check the "pressure point" down at your pedal and see if it is taking longer to engage after depressing pedal (do you have to push it quite a way until it starts to activate?). There is a post or three on here about picking up the slack on the pedal-it may apply here.
|
05-28-2023, 01:12 PM | #3 |
Not Yet Wild
Join Date: May 2023
Location: Bonneau Beach
Posts: 10
|
Re: Accelerator has little low range
Yes it’s almost bottomed out before e move. I will search for those posts..thanks
|
05-28-2023, 02:32 PM | #4 |
Gone Wild
Join Date: Apr 2013
Location: Deep Run, NC
Posts: 2,544
|
Re: Accelerator has little low range
It's usually because of wear at the throttle arm where the fork attaches to the throttle pedal. I've seen a few post where it's fixed by putting a zip tie around one of the fork post to tighten it up. Sorry I don't have any pics to post. Maybe someone does.
Sent from my SM-S906U using Tapatalk |
05-28-2023, 07:42 PM | #5 |
Gone Wild
Join Date: Oct 2007
Location: Snellville, Ga.
Posts: 1,304
|
Re: Accelerator has little low range
I have done the same conversion and have the same problem with the throttle. I believe there is a way to calibrate the throttle in the controller. I have not done this but have looked it up. Hope this helps.
|
Tags |
accelerator, mcor |
|
|
Similar Threads | ||||
Thread | Forum | |||
Accelerator Range | Icon | |||
What’s the range for 48v RXV? | Electric EZGO | |||
Not enough range | Electric Yamaha | |||
Need more range | Electric EZGO |