05-27-2023, 11:35 AM | #1 |
Not Yet Wild
Join Date: Jul 2016
Posts: 14
|
Ez go crank no start
I replaced my voltage regulator now motor will crank won’t start 1997 ezgo workhorse robins engine
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-27-2023, 11:40 AM | #2 |
Gone Wild
Join Date: Jul 2020
Location: NC
Posts: 773
|
Re: Ez go crank no start
My guess is that one of the wires at the solenoid got missed or is loose, or a ground is loose.
|
05-27-2023, 03:02 PM | #3 |
Not Yet Wild
Join Date: Jul 2016
Posts: 14
|
Re: Ez go crank no start
Is there a wireing diagram
|
05-27-2023, 03:27 PM | #4 |
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,148
|
Re: Ez go crank no start
|
05-27-2023, 06:09 PM | #5 |
Vintage tech
Join Date: Sep 2009
Location: South
Posts: 3,216
|
Re: Ez go crank no start
I agree with you JPonLKN. Black with white stripe ground wire coming from ignitor got knocked off small male spade of solenoid . Here is a picture of wiring. Put it back on and it will run.
|
05-28-2023, 06:45 AM | #6 |
Not Yet Wild
Join Date: Jul 2016
Posts: 14
|
Re: Ez go crank no start
Thank you will try that
|
05-28-2023, 01:54 PM | #7 |
Vintage tech
Join Date: Sep 2009
Location: South
Posts: 3,216
|
Re: Ez go crank no start
Here is the ignitor black wire with white stripe I was referring to that comes from the ignitor for ground. Not on the solenoid. You can see it would be easy to knock off.
|
06-10-2023, 10:53 AM | #8 |
Not Yet Wild
Join Date: Jul 2016
Posts: 14
|
Re: Ez go crank no start
Ok will crank won't start have power going to red wire on coil put nothing to spark plug replaced coil
|
06-18-2023, 08:29 AM | #9 |
Not Yet Wild
Join Date: Jul 2016
Posts: 14
|
Re: Ez go crank no start
Have no power going to the paulser coil from ignitor
|
06-18-2023, 09:39 AM | #10 |
Vintage tech
Join Date: Sep 2009
Location: South
Posts: 3,216
|
Re: Ez go crank no start
You are not supposed to have power going to pulser. Ohm your pulser. Should be 19-21 ohms. If that is correct then its good. If you have messed with pulser then you have to set the air gap. .020 is good enough on that.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Star ev | Electric golf carts | |||
Does a 2pg have a crank case pressure pickup tube inside the crank case? (pic) | Gas EZGO | |||
aligment of cam shaft, crank, and crank balance on g14 | Gas Yamaha | |||
New Star | Star and Fairplay | |||
When you wish upon a star.... | Golf Carts and Parts |