wiring 48v meter 2004 precedent

[wb9f]

Any tips as to where or what wire I can tap into to get my 48 Volts and ground for the 48V analog meter?
I just installed a complete light kit with head and tail, horn, flasher, signal, and brakes kights. I also installed a 48V Analog meter in the dash beside the low voltage indicator light. thanks Larry

[scottyb]

Follow the charger leads. Check the 2 posts they connect to with your voltmeter to verify 48v......WHAT? ........ no voltmeter?

[wb9f]

Thanks, for your reply. I would like to have the state of charge meter 48v work only when key is turned on.. thanks Larry

[scubabud]

Originally Posted by wb9f

Thanks, for your reply. I would like to have the state of charge meter 48v work only when key is turned on.. thanks Larry

On a 2005 and 2006 Precedent, (HOPEFULLY 2004,) there are 2 wires with female connectors on them just behind the dash and also where the factory gauge would be. They were put there by CC for their factory LCD vertical line gauge. You can use the 48+ volts from the key switch, (wired to hot with key on,) and the negative lead from the two wires left there for that purpose. Then you'll have the setup you want, gauge on with the key.

[wb9f]

Thanks for your input. Thats sound slike the info I needed. I'll check it out tommorrow thanks Larry

[scubabud]

Originally Posted by wb9f

Thanks for your input. Thats sound slike the info I needed. I'll check it out tommorrow thanks Larry

You're welcome...