09-10-2020, 07:03 AM | #11 |
Searching for The Way
Join Date: Oct 2009
Location: Medina, Ohio (NEOHIO)
Posts: 11,421
|
Re: Madjax 6 ...very frustrated
Let's make sure we are all talking the same language here. Refer to the photo.
When you say "Camber will pigeon toe in 1/4 inch." that sounds to me like "toe setting" not camber. I just want to make sure I understand. Can you post some pics of your setup and all your parts? Close ups of the tie rods ends and shocks. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-10-2020, 09:45 AM | #12 |
Not Yet Wild
Join Date: Aug 2020
Posts: 17
|
Re: Madjax 6 ...very frustrated
Ill get some pics. Sorry for the confusion. When I said camber will pigeon toe in I meant I start with zero camber. I drive it around the block a few times and then it has about a 1/4 negative camber. Also throws off my toe in (measurement I get from middle of front driver/passenger tires). I.e. My measurements will be 38 7/8. That measurement drops about half inch.
|
09-21-2020, 11:20 AM | #13 |
Not Yet Wild
Join Date: Sep 2020
Posts: 72
|
Re: Madjax 6 ...very frustrated
The lift I put on my TXT isnt a Madjax but it cambered real bad. About 1/4 negative each side. I ended up cutting the axle, straightening out and rewelding. So far so good. with your lift is the rear the same width as the front? My rear is 3 wider than the front.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
All new componants! no go!!! Frustrated!!! | Electric Club Car | |||
Frustrated and venting in NC | Electric Yamaha | |||
Frustrated and need help | Electric Yamaha | |||
Help Very Frustrated | Gas EZGO | |||
Frustrated in TEXAS | Electric Club Car |