|
Ezgo Gas Tech Resource info, wiring diagrams and how to's for Gas powered EZGO golf carts |
|
Thread Tools | Display Modes |
07-17-2007, 08:57 AM | #1 |
Born Wild
Join Date: Mar 2007
Location: Clover SC.
Posts: 5,552
|
EZGO 295 - 350 engine Valve Adjustment
EZGO Valve AdjustmentThis post was done by ezgomike elsewhere, its such a great post I wanted to include it over here for those who missed it. Thanks Mike Start with a cold engine(this ones at about 12 degrees for the pics). Remove 6 valve cover bolts, and pry off cover: Clean o-ring surface(blue arrows) carefully. Do not drop dirt in any holes. Check o-ring for damage, and make sure it is fully seated in cover(red arrows). Do this now, you'll be too excited later, and forget: Pick a valve. Turn cam lobe DOWN by rotating drive clutch by hand(red arrow): Loosen adjuster locknut 1/4-1/2 turn. Insert .004" feeler guage between cam, and lifter(red arrow): Turn adjuster until feeler guage has very slight drag, but is free. Hold the adjuster with a screwdriver, and tighten lock nut as shown. Then re-check with feeler again. Now, do the same for the remaining valves. The middle two are the intakes. Re-install cover(check the o-ring again). Tighten bolts to 5 ft/lbs. ***NOTE: No feeler gauge handy? if you lightly bottom the adjuster against the valve, then back off 1/4 turn on the adjuster, you will be very close to .005"*** |
|
|
Similar Threads | ||||
Thread | Forum | |||
85 EZGO robin engine valve adjustments | Gas EZGO | |||
HELP Valve Adjustment for 89 EZGO | Gas EZGO | |||
Valve adjustment Q | Gas EZGO | |||
Valve Adjustment | Gas EZGO | |||
help with valve adjustment | Gas Club Car |