EZ GO 600CBR 6 Speed gearing question.

MORE_GUNS · 06-20-2020, 01:35 AM

Hello everyone. This is my first post so thanks everyone in advance. I just bought a completed 94 EZ GO with a fuel injected 600 cbr engine and 6 speed transmission. This setup was built using the original sprockets off the bike with a live axle. I am going to use this for a sporting clays cart. I am wanting to get this cart geared as short as possible so I can keep 1st gear as slow as possible to haul 4 guys around the course. Does anyone have any suggestions on sproket sizes to get the lowest possible gearing?? I really appreciate the input. Thanks!!!!

06-20-2020, 01:35 AM	#1
MORE_GUNS Not Yet Wild Join Date: Jun 2020 Location: SE KS Posts: 1	EZ GO 600CBR 6 Speed gearing question. Hello everyone. This is my first post so thanks everyone in advance. I just bought a completed 94 EZ GO with a fuel injected 600 cbr engine and 6 speed transmission. This setup was built using the original sprockets off the bike with a live axle. I am going to use this for a sporting clays cart. I am wanting to get this cart geared as short as possible so I can keep 1st gear as slow as possible to haul 4 guys around the course. Does anyone have any suggestions on sproket sizes to get the lowest possible gearing?? I really appreciate the input. Thanks!!!!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Forum
Brand New Club Car Electric Differentials, High Speed 10:1 Gearing	Golf Carts and Parts
Spirit 5000 swap, gearing and top speed	Sled Engine Swaps
rear diff/gearing question	Gas EZGO
Cushman Truckster High Speed Gearing	Gas golf carts
gearing question	Gas Club Car