|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
08-12-2023, 04:09 PM | #1 |
Not Yet Wild
Join Date: Feb 2018
Posts: 56
|
Water resisting my new controller.
Hey Guys and Gail's
So I have the Ezgo 2008 TXT PDS Controller went bad so I got a Alltrax. No way the cover that covered the stock controller will fit over the new Alltrax and HD synolid. They say you don't need a cover for the Alltrax but I am not that sure. I can see where the Alltrax might be all sealed up but what about the plugs 10 pin, 4 pin and so on. I can see water getting down in those and corroding. Forr a temporary aid , I cut the top and one side of a clear square jug out and slipped it over the controller, synolid and wires. Hope this doesn't cause it to get too hot. I plan to inject some silicon greese type stuff in the plugs to displace the water. I don't plan on getting it wet. But who knows what can happen. I had a voltage reducer mounted near the floor near the battery's for around 6 years and it got to be intermittent . Took it apart and it was all rusted inside Had to get a replacement Made a diy cover for it out of a plastic jug and so far no problem What are your thoughts on this. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-12-2023, 04:25 PM | #2 |
WARRANTY VOID
Join Date: Aug 2021
Posts: 1,698
|
Re: Water resisting my new controller.
Dielectric grease for the harness connector and keep it out of the lake 😉
|
08-12-2023, 04:47 PM | #3 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,408
|
Re: Water resisting my new controller.
The Alltrax should not be covered. It has cooling towers and some models have built in fans. They need circulating air to dissipate heat. There are a few you tube videos proving it can run when wet. Dielectric grease is your friend in wet environments.
I'm not saying it is waterproof. I am saying it is water resistant. |
|
|
Similar Threads | ||||
Thread | Forum | |||
Water damaged curtis controller 1206AC5201 2017 2five | Electric EZGO | |||
Half speed resistor is resisting my reverse | Electric Club Car | |||
02 EZGO PDS Water Damage. 1-1 Code for Controller | Electric EZGO | |||
How to add 1-2 toggle switches in the controller box and still have it water tight | Electric EZGO |