|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
08-02-2020, 11:45 AM | #1 |
Not Yet Wild
Join Date: Jul 2020
Posts: 2
|
AM10039 Motor Centering Kit installation instructions
Looked around but I can seem to find any install instructions and the order of the components for the centering kit, kit is labeled bulk and did not include the instructions it’s supposed to come with.
Possibly someone scan them and post them? I know most you out can do this in your sleep, but this is my first go at it ! Thanks. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-02-2020, 01:04 PM | #2 |
Bonafide Nincompoop
Join Date: Dec 2015
Location: Charlottesburg Va
Posts: 8,987
|
Re: AM10039 Motor Centering Kit installation instructions
I'm sure they made some directions for it, but I've never seen any.
So it goes first on the input shaft: round washer spring spline washer rubber washer, cone side out then the rubber plug goes in the motor coupler. If it has an old one stuck in it make sure to pull it out with a small screwdriver/pick. It's a good idea to replace the bearing but that requires removing the end cap from the motor to access the brushes, and then the bearing has to be pressed off and back on. If you have a small jaw puller that should work fine to remove the old bearing and the new one can be tapped on with a socket and hammer. Be sure to not damage the speed magnet on the end of the armature. |
10-08-2020, 11:57 AM | #3 |
Gone Wild
Join Date: Nov 2018
Location: North Carolina
Posts: 433
|
Re: AM10039 Motor Centering Kit installation instructions
Fairtax4me
Just you clarify for the rubber washer. The "tip/pointy end" of the cone points toward the motor? I have not get the kit yet, but just wanted to make sure. |
10-09-2020, 05:57 PM | #4 |
Bonafide Nincompoop
Join Date: Dec 2015
Location: Charlottesburg Va
Posts: 8,987
|
Re: AM10039 Motor Centering Kit installation instructions
Yes, the cone side goes towards the motor.
The flat side of the rubber washer will be against the flat on the splined washer. |
10-09-2020, 06:11 PM | #5 |
Gone Wild
Join Date: Nov 2018
Location: North Carolina
Posts: 433
|
Re: AM10039 Motor Centering Kit installation instructions
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Baja cage installation instructions | Body and Paint | |||
627420 installation instructions | Electric EZGO | |||
Club car AM10039 Motor Centering Kit Install | Electric Club Car | |||
I need Disc Brakes installation instructions | Electric EZGO | |||
OBC Installation Instructions | Electric Club Car |