![]() |
|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
![]() ![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Not Yet Wild
Join Date: Jan 2009
Posts: 7
|
![]() I just finished rebiulding my first cart motor. It run good but after a few minutes of running it started leaking oil from the fan side crank seal. Is there a common reason? any advise would be greaty appreciated! thanks Bill
|
![]() |
![]() |
![]() |
|
![]() __________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
![]() |
#2 |
****tard supreme
![]() ![]() Join Date: Jun 2008
Location: waldo,wisconsin
Posts: 5,401
|
![]() are you sure its leaking at the seal, the sending unit my be loose or cracked.
|
![]() |
![]() |
![]() |
#3 |
Not Yet Wild
Join Date: Jan 2009
Posts: 7
|
![]() I removed the fan cover and started engine..oil seems to be comming from crank seal but its hard to be sure because the fan sprays it all around. seal is still in place. how does the engine vent the crank case? could it be building to much pressure?
|
![]() |
![]() |
![]() |
#4 |
Born Wild
Join Date: Mar 2007
Location: Clover SC.
Posts: 5,552
|
![]() Did you put in the small o-ring that goes in the side cover gasket?
|
![]() |
![]() |
![]() |
#5 |
Not Yet Wild
Join Date: Jan 2009
Posts: 7
|
![]() I just removed the fan and found that the crank seal was out about a 1/8" from flush. I inspected the seal it looked ok.. i re installed it and pricked punched it. started and ran engine in garage no leaks yet. will road test later.
|
![]() |
![]() |
![]() |
#6 |
Not Yet Wild
Join Date: Jan 2009
Posts: 7
|
![]() I removed side cover and sure enough the o ring was not there!! Installed o ring and re road tested... no leaks. thanks for your advise! runs good but is not very fast. can i tighten the spring on the governor with out hurting engine?
|
![]() |
![]() |
![]() |
#7 |
Gone Wild
![]() ![]() Join Date: Mar 2008
Location: Rockwall, Texas (Dallas / Ft. Worth)
Posts: 7,077
|
![]() |
|
|
![]() |
![]() |
![]() |
#8 |
Not Yet Wild
![]() Join Date: Mar 2013
Location: Kansas
Posts: 16
|
![]() I know im a few years late car18, but if your still on these forums, how hard is it to get into that portion of the motor, my seal is leaking too and i need to get into it with common tools. do you need a gear puller or need to completely remove fan from shaft to get into the case cover or is it easier than that?...thanks
|
![]() |
![]() |
![]() |
|
Thread Tools | |
Display Modes | |
|
![]() |
||||
Thread | Forum | |||
Engine Rebuild Manual EZGO 295cc | Gas EZGO | |||
EZGO 1995 295cc oil leak after rebuild | Gas EZGO | |||
EZGO 295cc engin | Golf Carts and Parts | |||
Re: Golf cart .vs. side by side | Golf Carts and Parts | |||
Golf cart .vs. side by side | Lifted Golf Carts |