lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car
Electric Club Car Electric DS, and Precedent golf cars



Post New Thread  Reply
 
Thread Tools Display Modes
Old 07-01-2012, 07:16 AM   #1
russb442
Gone Wild
Club Car
 
Join Date: Sep 2010
Location: Alexandria, La
Posts: 170
Default Had to replace mcor not sure if its adjusted iht

2001 CC Ds 48volt

Been doing a lot of work to my cart when I'm done it shold be Real nice

Last week the mcor went out and had to by a one on ($260$. At the same time I put in a knew motor in for seed ( waiting o my alltrax controller
Ok here is the question.... When I put an Ohm meter on then two am
Nd three wire going into speed control it starts out around 11.5 and when I press peddle it drops to 6. I thought ot should start out at 6k and drop to 00

Does this sound right. The carts works fine except with alittle jerk from start. I blame that on the bigger motor. When I say jerk I am talking about ( its ready to go)'
russb442 is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Old 07-02-2012, 08:57 PM   #2
russb442
Gone Wild
Club Car
 
Join Date: Sep 2010
Location: Alexandria, La
Posts: 170
Default Re: Had to replace mcor not sure if its adjusted iht

Bump please help
russb442 is offline   Reply With Quote
Old 07-03-2012, 08:23 AM   #3
shadowman
The Last Moja Morani
 
shadowman's Avatar
Club Car
 
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
Default Re: Had to replace mcor not sure if its adjusted iht

russ someone will be along.............................
shadowman is offline   Reply With Quote
Old 07-03-2012, 01:42 PM   #4
TahoeDawgZ71
revolutiongolfcars.com
 
TahoeDawgZ71's Avatar
Club Car
 
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 10,224
Default Re: Had to replace mcor not sure if its adjusted iht

MCOR throttle frequency should be checked across the pins where the yellow and white wires plug in. It should range from around 6500 to 1100 ohms
TahoeDawgZ71 is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
Can the Drive Belt tension be adjusted Gas EZGO
Should valves be adjusted hot or cold ? Gas EZGO
TXT/RXV/Huh? and My GOV Adjusted? Gas EZGO
Adjusted Brakes and Wha Lah! Electric EZGO
Steering wheel needs to be adjusted to run right side up Gas Club Car


All times are GMT -5. The time now is 11:40 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.