|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
06-01-2011, 08:50 PM | #1 |
Not Yet Wild
Join Date: Jun 2011
Posts: 2
|
MCI to pulsar ignition
The motor I have is set up for MCI and the old motor I am taking out is pulsar ignition. Can I change all the electronics from the pulsar engine to the MCI engine to make it run? This is being done on a EZ Go.cart. The engines are both EH29C's
Last edited by Damato; 06-01-2011 at 10:05 PM.. Reason: More information |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-01-2011, 09:48 PM | #2 |
Hammer Down !!!!
Join Date: Jun 2010
Location: Lake Geneva, WI
Posts: 2,681
|
Re: MCI to pulsar ignition
Here's the conversion diagram for 2PG, should be relatively identical for all 2-strokes (and if I recall, applies to early 4 strokes too)
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Yamaha G9-Ignition Coil & Ignition Switch-Help | Gas Yamaha | |||
Pulsar Coil and Ignitor | Gas EZGO | |||
Pulsar coil | Gas EZGO | |||
Pulsar coil location | Gas EZGO | |||
pulsar coil needed | Gas EZGO |