|
Big Block Talk! Everything about swapping a big block engine into your cart! |
|
Thread Tools | Display Modes |
06-28-2021, 06:03 PM | #51 |
VC 460 CLONE GONE WILD
Join Date: Oct 2014
Location: Ray BY The Bay NJ
Posts: 10,647
|
Re: carb,carbs,carbs
If that 30 mm carb from performance 670 is indeed a Walbro from the Kohler K321-341 engines that could be a real easy solution for both the 625 and 670 engines.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-13-2021, 10:16 AM | #52 |
Gone Wild
Join Date: Oct 2019
Location: Masontown WV
Posts: 152
|
Re: carb,carbs,carbs
[QUOTE=raydhd;1797289]That should do it. Just wanted to say this is a good carb
|
12-16-2021, 04:33 PM | #53 |
VC 460 CLONE GONE WILD
Join Date: Oct 2014
Location: Ray BY The Bay NJ
Posts: 10,647
|
Re: carb,carbs,carbs
Bump
|
08-18-2022, 11:23 AM | #54 |
VC 460 CLONE GONE WILD
Join Date: Oct 2014
Location: Ray BY The Bay NJ
Posts: 10,647
|
Re: carb,carbs,carbs
Interestingly enough the guys on carsandcameras had their highly built twin turbo HF 670 on a dyno for a carb selection session. They found even with all the mods they had a 38 mm Mikuni was TOO large for the engine. I have always maintained a 36 mm would be the max for this sized engine and then only when it was going to be used at high rpms with little regard for low end drive ability. The 34 mm unit is the one all the pro builders recommend for this engine. Great to see some real on line testing. Nothing worse carbs wise then one that is too large for a decent intake signal.
|
08-25-2022, 11:24 AM | #55 |
Gone Wild
Join Date: Nov 2015
Posts: 188
|
Re: carb,carbs,carbs
I'm not well versed on all the carb terminology used in this thread, however I am knowledgable in carbs in general. I have a few Mikuni carbs for a Polaris Ranger 500 because I'm constantly messing around with my Ranger and will swap carbs when I need to rebuild; can I use one of these on a 670? I will be swapping the engine in to a 2013 TXT soon so I don't know how it is going to run stock but if I can use the Polaris carb that would save me from buying a new one. I have to believe that throttle cable/choke could be a challenge and possibly I'd have to change jets? I really don't know the size but think it is 34mm.
|
08-25-2022, 01:32 PM | #56 |
VC 460 CLONE GONE WILD
Join Date: Oct 2014
Location: Ray BY The Bay NJ
Posts: 10,647
|
Re: carb,carbs,carbs
Performance 670 sells the manifold to use a Mikuni on the HF 670. Jetting is always another issue. Fortunately there are adjustable jets available for the stock type single cylinder clone carbs which makes that an easy job.
|
08-25-2022, 09:41 PM | #57 | |
Gone Wild
Join Date: May 2022
Location: Pensacola, FL
Posts: 291
|
Re: carb,carbs,carbs
Quote:
|
|
08-28-2022, 11:58 AM | #58 |
VC 460 CLONE GONE WILD
Join Date: Oct 2014
Location: Ray BY The Bay NJ
Posts: 10,647
|
Re: carb,carbs,carbs
Yes I did see that. Luckily for them despite the super high revs after the 780 blew up the engine appears to be intact. Again that will be a stay tuned situation. It will be interesting to see what they do about a primary clutch. A sled clutch would work well BUT I don't know if there is one for a 1" straight shaft.
|
09-03-2022, 06:02 PM | #59 |
Gone Wild
Join Date: Jan 2014
Location: South Jersey
Posts: 623
|
Re: carb,carbs,carbs
What size would you recommend for a mild 16hp vanny? 30? 32?
|
09-03-2022, 08:39 PM | #60 |
VC 460 CLONE GONE WILD
Join Date: Oct 2014
Location: Ray BY The Bay NJ
Posts: 10,647
|
Re: carb,carbs,carbs
Depending on your desire for max power or max throttle response something in the 30-34 mm range. At 480 cc very near a upper end the ccs of a single cylinder clone. If it were me the 30 would be my choice as throttle response is more important than maximum top end power.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Good carbs bad carbs. | Gas Yamaha | |||
Jets on the GY6 Carbs? | Clone Engine Swaps | |||
Best Carbs for GX390 | Clone Engine Swaps | |||
Is this how the carbs go back on | Gas Harley Davidson | |||
Carbs for 16 hp clones | Big Block Talk! |