xct 500 alltrax programming how to

[Vabeachg19e]

So i have a 2001 g19 48v. I just put a 500 amp xct controller and admiral B2 motor. Looking for how to advice on programming and exactly what should I expect from this combo? Speed? How to make the cart faster? The cart is lifted with bigger tires and im getting right at 11mph with current factory setting. Thanks for any help.

[scottyb]

This should come preprogrammed, tell us what you are getting from this high torque set up

[Vabeachg19e]

I got it PLENTY of torque. She is a beast no doubt. I just have read other guys playing around with there controllers by programming them to go faster or slower. I connected to the controller yesterday just to get familiar with program and check it out. I changed nothing because i dont know much about this stuff. Was just seeing if i could get more speed for playing around. This combo has performed awesome and is exactly what i expected.

[scottyb]

Post some pics of the program settings like screen shots or even cell phone pics showing rpm limit, amperage max, etc.

[Vabeachg19e]

Rpm limit is 6000 rpm. I will check on amp max tomorrow.

[Vabeachg19e]

[Volt_Ampere]

Use the logging function to see what RPM you are getting. If it is reaching the max, then it may be able to go a little faster if you raise the RPM limit. You may be exceeding the recommended RPM for your motor though so don't do this without finding that out. The logging function is a great way to see what is going on when you drive your cart.

[scottyb]

It looks to be turned all the way up

I did not see the motor rpm limit.

[Vabeachg19e]

[Vabeachg19e]

I do not have the red /green and black wires hooked up off the side of the motor...the last motor didnt have them hooked up either