|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
05-07-2013, 01:05 PM
|
#1 |
|
Not Yet Wild
Join Date: Aug 2011
Posts: 44
|
priming fuel on 83 G1
How do you prime a fuel pump on a G-1 golf cart that ran out of gas, cannot get gas pumping.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
05-07-2013, 07:11 PM
|
#2 |
|
Getting Wild
Join Date: Jan 2013
Location: st. john's nl canada
Posts: 139
|
Re: priming fuel on 83 G1
I just finished a engine rebuild and all I done was take off the fuel line from the top of the tank and got a squeeze bottle and put gas down into the gas line till it was full. I then hooked the line back to tank spilled a bit but not a big deal, then started it right up. Hope that helps but I am sure there could be a easier way and I am sure someone on BGW will tell you. good luck.
|
|
|
|
|
05-07-2013, 07:53 PM
|
#3 |
|
Gone Wild
Join Date: Nov 2011
Posts: 232
|
Re: priming fuel on 83 G1
I take the line off the carb, the cap off the tank & put air to it you'll notice right away gas flowing from the hose. just don't put very much pressure in the tank.
|
|
|
|
|
05-08-2013, 01:53 PM
|
#4 |
|
Getting Wild
Join Date: Mar 2013
Posts: 116
|
Re: priming fuel on 83 G1
My tank has a small rubber vent cap on top, I pulled it out and stuck a clean gas line in the hole and blew in it till gas came out the fuel pump supply nipple
|
|
|
|
|
06-29-2022, 06:49 PM
|
#5 |
|
Not Yet Wild
Join Date: Jun 2022
Posts: 1
|
Re: priming fuel on 83 G1
Installed hand pump primer connected to fuel line. Made all the difference for mine
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 1988 Parcar Fuel pump Or no Fuel pump? | Gas Columbia ParCar | |||
| fuel filter does not fit inside fuel hose... | Gas Yamaha | |||
| fuel pump not putting out fuel | Gas EZGO | |||
| How Clean is Clean...Before Priming | Body and Paint | |||
| Priming and sealing after AP | Body and Paint | |||
Linear Mode
