Replacing Front LED Light with 2 LEDs

[ousuxndallas]

My Club Car Precedent is wired up with the Madjax LED light kit, so it has the front light bar and the rear brake lights.

I want to replace just the front LED light bar. How do I do this?

I removed the light bar, and noticed there were 6 wires connecting it. Two on the left side ( A. red and black wires), two in the middle (B) and 2 on the right (C).

I tried to connect a new light by connecting to A, the red and black wire previously on the left side of the old light.

Doesn't work. Can't even get power reading from my volt meter.

Any thoughts? I want to keep the old harnesses from the Madjax kit if possible, because it's clean and the rear brake lights still work.

[Sergio]

The "A" and "C" wire pairs are for the turn signals and will only have power when they are ON for that side (left/right).

You want to use the "B" wire pair for the headlights.

[ousuxndallas]

Originally Posted by Sergio

The "A" and "C" wire pairs are for the turn signals and will only have power when they are ON for that side (left/right).



You want to use the "B" wire pair for the headlights.

Thanks, man. That was it. Installed and works perfectly.

[HogKiller]

Originally Posted by ousuxndallas

Thanks, man. That was it. Installed and works perfectly.

Which All Sports brush guard is that and are you happy with it?

[ousuxndallas]

This one

https://www.americanliftkits.com/pre...d-brush-guard/

I like it. Super sturdy, knocks down brush no problem at my lease.