|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
09-08-2018, 01:30 PM | #1 |
Not Yet Wild
Join Date: Aug 2018
Location: Maryland
Posts: 34
|
Regan 1 wiring digram question
Red and green wire off motor to controller look like 14-16 ga what do they do no. 20 and 21 in diagram also did the obc by pass can I follow the wires back and remove obc completely or just leave it hang thanks
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-08-2018, 04:39 PM | #2 |
Bonafide Nincompoop
Join Date: Dec 2015
Location: Charlottesburg Va
Posts: 8,987
|
Re: Regan 1 wiring digram question
Red green and black small wires go to the speed sensor.
Pretty sure you can remove the OBC if you jump the lockout wire that goes to the controller. It keeps the controller in lockout when the charger is plugged in so it can't be driven. Not sure exactly which it is, either yellow or green. Hopefully someone who has done that can provide some details. |
09-08-2018, 10:08 PM | #3 |
MOD of all BS!
Join Date: Sep 2011
Location: Florida
Posts: 17,477
|
Re: Regan 1 wiring digram question
Look at your referenced diagram and you need to disconnect the yellow wire's bullet connector (which is #19) and then run that wire from the controller side directly back to Controller "N" or to the Main Pack Negative to prevent the lockout.
|
09-09-2018, 06:10 AM | #4 |
Not Yet Wild
Join Date: Aug 2018
Location: Maryland
Posts: 34
|
Re: Regan 1 wiring digram question
I did the obc by pass like was discussed earlier when. Was repairing wires from meltdown u found red and green wires hanging from plug unattached made all wiring repairs but was unsure if these where unhooked all along or if I should reattach them
|
09-09-2018, 02:24 PM | #5 |
MOD of all BS!
Join Date: Sep 2011
Location: Florida
Posts: 17,477
|
Re: Regan 1 wiring digram question
They should be hooked up if your speed sensor is working correctly. A regen I cart could run without them connected, but a Regen II or IQ will be in Limp mode without them connected.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
72 harley wire digram | Harley Davidson | |||
96 regan no go | Electric Club Car | |||
99 cc regan | Electric Club Car | |||
ezgo battery digram question | Electric EZGO | |||
how to tell if it is a regan | Electric golf carts |